Citation II V6-173 2.8L VIN X 2-bbl (1985)
NOTICE:
Injectors with the correct spray pattern have already been installed on engines with a build date code of 0107 (January 7th) or later.
Example:
T 01 07 CAF
This code is stamped on the horizontal machined surface of the block just forward of the intake manifold.
If the engine continues to exhibit a hesitation after the above updates, follow diagnostic procedures for hesitation in Section B-Symptoms, Section 6E3 of
the Service Manual.
NOTICE:
One of the steps in the Service Manual is to perform the injector balance test. It is important to run this test because this test will identify
plugged injectors. If the injectors are plugged clean the injectors using recommended service procedures.
Labor Operation Number:
Reference Chart II.
Labor Time
Reference Chart II.
Chart I:Procedure to Identify & Install Latest PROM
