Citation II V6-173 2.8L VIN X 2-bbl (1985)
Figure 3 - Housing Reference Mark (Typical) and Rack Centering Measurement
4.
Rack must be centered in housing. (See Figure 3 on page 2.)
5.
Wipe housing bore clean of any foreign material.
Important
Apply a liberal quantity of grease to the valve housing bore, Be sure to fill grooves with grease. This will ease ressembly of valve Into housing.
Figure 10 Bearing and Annulus Inspection
Inspect
Inspect stub shaft bearing annulus for flatness and damage. Clean before reassembly.
6.
Align stub shaft flat or notch with second mark on housing made during disassembly. (See step 9 on page 2.) Install pinion and valve assembly
with spool shaft retaining ring, and valve body rings included, into housing using J 37090 to prevent damage to valve rings during assembly.
