Citation II V6-173 2.8L VIN X 2-bbl (1985)
To Service 1986 (after Julian date 184) and 1987 THM 125C
When servicing the forward clutch assemblies on a 1986 (after Julian date 184) or 1987 THM 125C transaxle, it is important to select the correct
backing plate. The backing plate selection effects piston travel and shift feel.
Figure 2 - Forward Clutch Backing Plate Selection
To check the forward clutch backing plate selection, after assembling the clutch pack into the housing, press down on the backing plate with
approximately 10 lbs. of force and check the gap between the backing plate and snap ring. If the gap is larger than 1.49 mm use the next thicker backing
plate, and if smaller than 0.67 use the next thinner backing plate. Refer to Figure 2 for alternate backing plate selections.
To service the lo and reverse clutch housing and/or lo and reverse clutch pack assembly, order the required part or parts listed below.
SERVICE PARTS INFORMATION
Part Number
Part Name
8664167
Forward Clutch Assembly, Complete
8664152
Lo and Reverse Clutch Housing Assembly
8664151
Lo and Reverse Clutch Pack Assembly