Cobalt L4-2.0L SC VIN P (2005)
discard Corporate Bulletin Number 05-08-64-036A (Section 08 - Body and Accessories).
Condition
Some customers may comment that the fabric on the door trim is pulling away from the pull cup.
Cause
This may be due to the bezel on the pull cup. It is not wide enough to account for the variation in the water cut jet process on the trim panel.
Correction
Replace the pull cup with a new design cup that has a wider bezel following the procedure below.
For vehicles without power windows and locks
1.
Remove the trim plate in the bottom of the pull cup with a small screwdriver.
2.
Remove the two screws.
3.
Remove the pull cup.
4.
Install the new pull cup with a wider bezel.
5.
Install the two screws.
Tighten
Tighten the screw to 2 N.m (18 lb in).
6.
Install the trim plate in the bottom of the pull cup.
For vehicles with power windows and/or locks
1.
Remove the trim plate in the bottom of the pull cup with a small screwdriver.
2.
Remove the two screws.
3.
Remove the door pull cup and switch plate.
4.
Disconnect the electrical connectors.
5.
Install the beauty ring under the pull cup and switch plate.
6.
Install the electrical connectors.
7.
Install the switch plate into the door panel. Use a plastic trim tool and hold the trim down in front as shown in the illustration above.
