Cobalt L4-2.0L SC VIN P (2005)
5. Locate and remove the AIR BAG (IGN) and AIR BAG (BATT) fuses from the BCM fuse center.
IMPORTANT: This inflatable restraint sensing and diagnostic module (SDM) has two fused power inputs. To ensure there is no unwanted SIR
deployment, personal injury, or unnecessary SIR system repairs, remove both AIR BAG (IGN) and AIR BAG (BATT) fuses from the BCM fuse
center. With the AIR BAG fuses removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
6. Open front hood, and locate the front end sensor also known as the electronic frontal sensor (EFS) (2).
7. Remove the connector position assurance (CPA) from the front end sensor connector.
8. Remove the front end sensor connector from the front end sensor (2).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the front end sensor connector to the front end sensor (2).
3. Connect the CPA to the front end sensor connector.
