Cobalt L4-2.0L SC VIN P (2005)
17. Connect the roof rail module-right connector to the vehicle harness connector.
18. Install the CPA to the roof rail module-right connector.
19. Install the garnish molding to the right upper lock pillar.
20. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the BCM fuse center.
21. Install the BCM fuse center cover.
22. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
23. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information.