Cobalt L4-2.0L SC VIN P (2005)
11. Install a large C-clamp, over the body of the brake caliper with the C-clamp ends against the rear of the caliper body and against the outer brake
pad.
12. Notice: When using a large C-clamp to compress a caliper piston into a caliper bore of a caliper equipped with an integral park brake mechanism,
do not exceed more than 1 mm (0.039 inch) of piston travel. Exceeding this amount of piston travel will cause damage to the internal adjusting
mechanism and/or the integral park brake mechanism.
Tighten the C-clamp just enough to compress the caliper piston 1 mm (0.039 inch) of travel only.
13. Remove the C-clamp from the caliper.
14. Remove the brake hose-to-caliper bolt (1) from the brake caliper.
15. Remove the brake hose (3) from the brake caliper.
16. Remove and discard the 2 copper brake hose gaskets (2). These gaskets may be stuck to the brake caliper and/or the brake hose end (3).
17. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination.
18. While using a wrench on the flats of the caliper guide pins (1), remove the brake caliper guide pin bolts (2).