Cobalt L4-2.0L SC VIN P (2005)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Unclip the electrical wiring harness from the oil level indicator tube.
3. Lower the vehicle.
4. Remove the oil level indicator tube bolt and unclip the upper wiring harness.
5. Remove the oil level indicator tube.
6. Remove the oil level indicator tube seal.
Installation Procedure
1. Install the oil level indicator tube seal.
2. Install the oil level indicator tube.
3. Clip the upper electrical wiring harness to the oil level indicator tube.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil level indicator tube bolt.
^
Tighten the oil level indicator tube bolt to 10 Nm (89 inch lbs.).
5. Raise the vehicle.
6. Clip the lower wiring harness.
7. Lower the vehicle.
