Cobalt L4-2.0L SC VIN P (2005)
1. Install the filter to the housing.
2. Install the oil filter cap with filter.
3. Install the oil filter to the housing.
4. Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.
Notice: Refer to Fastener Notice in Service Precautions.
Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.
Use a 32 mm (1 1/4 inch) socket with a long extension (1/2 to 3/8 reducer helps if available) and ratchet on the hex on the top of the oil filter cap.
^
Tighten the oil filter cap until fully seated, DO NOT exceed 25 Nm (18 ft. lbs.).
5. Raise the vehicle.
6. Install the oil pan drain plug.
^
Tighten the oil pan drain plug to 25 Nm (18 ft. lbs.).
7. Lower the vehicle.
8. Fill the engine with oil.
