Cobalt L4-2.0L SC VIN P (2005)
Control Assembly: Service and Repair
HVAC CONTROL ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Remove the I/P center trim panel.
2. Remove the HVAC control module assembly screws.
3. Remove the HVAC control module assembly.
4. Disconnect the HVAC control module assembly electrical connectors.
INSTALLATION PROCEDURE
1. Connect the HVAC control module assembly electrical connectors.
2. Install the HVAC control module assembly.
3. Install the HVAC control module screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.2 N.m (19 lb in).
4. Install the I/P center trim panel.
