Cobalt L4-2.0L SC VIN P (2005)
5. Inspect the foam heater core seal on the lower HVAC case. If damaged, replace using Kent Industries adhesive black foam tape P/N 46480 or
equivalent.
6. Install the heater core into the HVAC module.
7. Install the heater core cover and the screws.
IMPORTANT: Verify that the heater core cover is properly positioned and is fully seated on the HVAC module. Install new screws that secure the
heater core cover to the HVAC module.
Tighten the screws to 1.8 N.m (16 lb in).
8. Replace the drain tube seal.