Cobalt L4-2.0L SC VIN P (2005)
Negative: Service and Repair
Disconnect/Connect Procedure
BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE
REMOVAL PROCEDURE
1. Record all of the vehicle preset radio stations.
CAUTION:
-
Refer to Battery Disconnect Caution in Service Precautions.
-
Refer to SIR Caution in Service Precaution.
2. Turn OFF all the lamps and the accessories.
3. Make sure the ignition switch is in the OFF position.
4. Disconnect the battery negative cable from the battery (2).
INSTALLATION PROCEDURE
1. Connect the battery negative cable to the battery (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 15 N.m (11 lb ft).
IMPORTANT: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the
battery cable to the battery terminal.
