Cobalt L4-2.0L SC VIN P (2005)
1. Place the battery cable in the vehicle using the original routing.
2. Connect the positive battery cable (1) to the starter and the positive cable nut (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the starter terminal nut to 17 N.m (13 lb ft).
3. Tape the positive battery cable to the negative battery cable near the transmission.
4. Lower the vehicle.
5. Connect the positive cable (2) to the underhood junction block.
6. Connect the positive battery cable nut (1) to the underhood junction block.
Tighten the bolt (2) to 17 N.m (13 lb ft).
7. Connect the negative battery cable to the battery.
