Cobalt L4-2.0L SC VIN P (2005)
Fluid Filter - A/T: Service and Repair
Oil Filter and Seal Replacement
^
Tools Required:
-
J 6125-1B Slide Hammer
-
J 23129 Axle Boot Remover
Removal Procedure
1. Raise and support the vehicle.
Caution: Refer to Vehicle Lifting Caution in Service Precautions.
2. Place the drain pan under the transaxle oil pan.
3. Remove the oil pan bolts from only the front and the sides.
Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.
4. Loosen the rear oil pan bolts about 4 turns.
5. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
6. Inspect the fluid color.
7. Remove the remaining oil pan bolts.
8. Remove the oil pan.
