Cobalt L4-2.0L SC VIN P (2005)
Torque Converter: Service and Repair
Torque Converter, Turbine Shaft Seal Replacement
Removal Procedure
1. Caution: Refer to Battery Disconnect Caution in Service Precautions.
Disconnect the negative battery cable.
2. Remove the transmission assembly from the vehicle.
3. Remove the torque convertor assembly from the transmission.
4. Remove the torque convertor O-ring seal from the end of the turbine shaft. Use a screwdriver.
Installation Procedure
1. Install a new torque convertor O-ring seal on the end of the turbine shaft.
2. Install the torque convertor onto the transmission.
3. Install the transmission into the vehicle.
4. Connect the negative battery cable.
5. Adjust the transmission oil level.
