Cobalt L4-2.0L SC VIN P (2005)
1. Important: The transaxle bolts must be torqued in a mandatory sequence as shown.
Notice: Install the front transaxle mount and transaxle bolts.
^
Tighten the bolts to 90 Nm (66 ft. lbs.).
2. Hand tighten the front transaxle mount thru bolt.
3. Important: The front and rear transmission mounts must be allowed to settle with the thru bolts loosened.
Loosen the rear transmount thru bolt.
4. Tighten the transmission mount thru bolts in the following order.
1. Tighten the rear bolt to 100 Nm (74 ft. lbs.).
2. Tighten the front bolt to 100 Nm (74 ft. lbs.).
5. Lower the vehicle.