Cobalt L4-2.0L SC VIN P (2005)
3. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Notice: Refer to Fastener Notice in Service Precautions.
4. ^
Tighten the clutch cover to flywheel bolts in the sequence shown.
^
Tighten the bolts to 30 Nm (22 ft. lbs.).
5. Recheck each bolt torque using the tightening sequence.
6. Remove the J 43482.
Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
7. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
8. Install the transmission.
9. Bleed the hydraulic system.
10. Connect the negative battery cable.