Cobalt L4-2.0L SC VIN P (2005)
10. Install the positive battery cables (1) to the underhood electrical center.
^
Tighten the positive cable nut to 15 Nm (11 ft. lbs.).
11. Connect the engine control module harness connectors (3, 4).
12. Connect the negative battery cable.
13. Install the underhood electrical center cover.
Transmission Mount Bracket Replacement - Rear
Transmission Mount Bracket Replacement - Rear
Removal Procedure
1. Remove the rear transaxle mount.
2. Remove the axle boot heat shield bolts.
3. Remove the axle boot heat shield.
