Cobalt L4-2.2L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Bracket Replacement (With JL4)
Brake Pressure Modulator Valve Bracket Replacement (With JL4)
Removal Procedure
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Turn the ignition switch to the OFF position.
2. Remove the cover from the engine control module (ECM) and transmission control module (TCM).
3. Release the brake pipes from the retainer on the wheelhouse panel.
4. Remove the brake pressure modulator valve (BPMV) bolt (1).
5. Remove the BPMV (1) from the bracket by pulling straight upward.
