Cobalt L4-2.2L (2008)
3. Install the brake pedal assembly, with the accelerator pedal position sensor to the vehicle.
4. Connect the brake pedal position sensor electrical connector.
5. Install the vacuum brake booster nuts (1).
Tighten the nuts to 17 N.m (14 lb ft).
6. Install the brake pedal bracket-to-steering column bracket bolt.
Tighten the bolt to 25 N.m (18 lb ft).
7. Apply a thin coat of high temperature grease GM P/N 12345994 (Canadian P/N 10953501) to the pushrod pin on the brake pedal.
8. Install the brake pedal pushrod to the brake pedal pivot pin.
9. Install the brake pedal pushrod washer (1).
