Cobalt L4-2.2L (2008)
10. Install the brake pedal pushrod nut (1).
Tighten the nut to 10 N.m (89 lb in).
11. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
12. Connect the electrical connector to the accelerator pedal position sensor.
13. Secure the accelerator pedal position sensor jumper harness to the brake pedal bracket.
14. Secure the electric power steering wiring harness to the brake pedal bracket.
15. Install the steering column opening filler. Refer to Steering Column Opening Filler Replacement .