Cobalt L4-2.2L (2008)
6. Hold the threaded shaft of the cylinder bore sleeve puller EN 45680-852 upward in order to retain the shoe alignment to the bottom of the cylinder
bore sleeve.
7. Install the fixture EN 456850-851 (4) onto the threaded shaft of the cylinder bore sleeve puller EN 456850-852 and the engine block.
8. Install the bearing (3) and the nut (1).
9. Tighten the nut (1) to the bearing (3).
Notice: Refer to Fastener Notice .
Important: Use four old cylinder head bolts for the attaching bolts.
10. Install and tighten the 4 attaching bolts (2) into the cylinder head bolt holes of the block.
Tighten the bolts to 15 N.m (11 lb ft).
11. Rotate the nut clockwise in order to remove the cylinder bore sleeve.
