Cobalt L4-2.2L (2008)
9. Using a torque wrench, torque the threaded shaft of the fixture EN 45680-851/cylinder bore sleeve installer EN 45680-853 assembly to 102 N.m
(75 lb ft) in order to completely seat the cylinder bore sleeve in the cylinder block. With the cylinder bore sleeve properly installed, a minimal
portion of the cylinder bore sleeve flange will protrude above the block deck surface.
10. Remove the fixture EN 45680-851/cylinder bore sleeve installer EN 45680-853 assembly (1) from the cylinder block (2).
Cylinder Liner Trimming
*
EN 45680-865 Debris Collector (3)
*
EN 45680-861 Trim Tool Assembly (2)
*
Air Control Valve (1)
