Cobalt L4-2.2L (2008)
Heater Core: Service and Repair
Heater Core Replacement
Heater Core Replacement
Tools Required
J 38185 Hose Clamp Pliers
Caution: With a pressurized cooling system, the coolant temperature in the radiator can be considerably higher than the boiling point of the
solution at atmospheric pressure. Removal of the surge tank cap, while the cooling system is hot and under high pressure, causes the solution to
boil instantaneously with explosive force. This will cause the solution to spew out over the engine, the fenders, and the person removing the cap.
Serious bodily injury may result.
Removal Procedure
1. Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716 Fill) Cooling System Draining and Filling (2.2L (L61), 2.4L
(LE5)).
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Place a drain pan under the water pump drain port.
4. Loosen the water pump drain bolt and drain the coolant from the water pump.
Notice: Refer to Fastener Notice.
5. Close and tighten the water pump drain bolt.
Tighten the water pump drain bolt to 10 N.m (88 lb in).
6. Lower the vehicle.
