Cobalt L4-2.2L (2008)
Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.
Notice: Refer to Fastener Notice .
Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.
3. Use J 44887 on the oil filter cap .
Tighten the oil filter cap until fully seated, DO NOT exceed 25 N.m (18 lb ft).
4. Install the oil pan drain plug.
Tighten the oil pan drain plug to 25 N.m (18 lb ft).
5. Lower the vehicle.
6. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations .
