Cobalt L4-2.2L (2008)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor Replacement (With RPO Code NT7)
Fuel Level Sensor Replacement (With RPO Code NT7)
Removal Procedure
Caution: Refer to Gasoline/Gasoline Vapors Caution.
1. Remove the fuel pump module.
2. Push clockwise on the pressure sensor (1) in the 2 locations shown until an audible click is heard.
3. Raise the pressure sensor until the sensor is removed from the bucket.
4. Disconnect the fuel level sensor electrical connector (1) from the module cover.
5. Remove the fuel level sensor electrical connector wiring (2) from around the fuel pipe.
6. Push in the fuel level sensor retaining tabs (3) in order to disengage the sensor tabs from the module bucket.