Cobalt L4-2.2L (2008)
Negative: Service and Repair
Battery Negative Cable Replacement (Engine To Chassis)
Battery Negative Cable Replacement (Engine to Chassis)
Removal Procedure
Important:
*
Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
*
Always route the replacement cable the same way as the original cable.
1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. If equipped with regular production options (RPOs) L61/LE5 with MN5 perform the following, remove the engine harness ground nut (4).
4. Remove the engine harness ground terminal (3) from the stud (1).
5. Remove the negative battery cable ground terminal (2) from the stud (1).
