Cobalt L4-2.2L (2008)
3. If equipped with RPO LSJ, perform the following steps, install the positive battery cable terminal (2) to the starter solenoid.
Notice: Refer to Fastener Notice.
4. Install the starter solenoid terminal nut (3).
Tighten the nut to 17 N.m (13 lb ft).
5. If equipped with RPOs L61 or LE5, perform the following steps, Install the positive battery cable terminal (3) to the starter solenoid.
6. Install the starter solenoid terminal nut (4).
Tighten the nut to 17 N.m (13 lb ft).
7. Lower the vehicle.