Cobalt L4-2.2L (2008)
Notice: Refer to Fastener Notice .
1. Install the intermediate/4th band servo piston spring, the servo and the servo cover bolts.
Tighten the bolts to 12 N.m (106 lb in).
2. Install the filter and the pan. Refer to Automatic Transmission Fluid Filter and Seal Replacement (See: Fluid Filter - A/T/Service and Repair) .
3. Lower the vehicle.
4. Fill the transmission with DEXRON(R) VI fluid.
5. Inspect the transmission oil level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General
Diagnostics/Transmission Fluid Check) .
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM),
powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance
may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Description and Operation/Transmission Adaptive Functions) .
