Cobalt L4-2.2L (2008)
3. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Notice: Refer to Fastener Notice .
4. Tighten the clutch cover to flywheel bolts in the sequence shown.
Tighten the bolts to 30 N.m (22 lb ft).
5. Recheck each bolt torque using the tightening sequence.
6. Remove the J 43482 .
Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
7. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
8. Install the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/MU3 - Manual Transaxle/Transmission Replacement) .
9. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding (See: Clutch Hydraulic System/Service and Repair) .
10. Connect the negative battery cable.