Cobalt L4-2.2L (2008)
2. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Notice: Refer to Fastener Notice .
3. Install the clutch cover to flywheel bolts.
Follow the tightening sequence. Tighten the bolts to 24 N.m (18 lb ft).
4. Remove the J 43482 .
Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
5. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
6. Install the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Getrag 5 Speed - Manual Transmission/Transmission Replacement) .
7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding (See: Clutch Hydraulic System/Service and Repair) .
8. Connect the negative battery cable.
