Cobalt L4-2.2L (2008)
*
The shaft out board boot (1)
*
The shaft boot grooves
*
The swage ring (2)
Tighten each bolt of DT-47732 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are
bottomed.
Place the remaining grease from the service kit inside the seal.
26. Mount DT-47732 in a vise and proceed as follows:
Measure approximately 17.5 mm (11/16 in) up from the bottom edge of the CV outer joint assembly.
27. Slide the large diameter of the seal with the large seal retaining clamp in place over the outside of CV joint.
Important: The CV joint seal must not be dimpled, stretched or out of shape in any way. If seal is not shaped correctly, equalize pressure
in the seal and shape the seal properly by hand.
28. Locate the seal lip to the ridge of the CV outer joint assembly as measured in the previous step.
29. Crimp seal retaining clamp (1) with J 35910 , a breaker bar (3), and a torque wrench (2).
Tighten seal retaining clamp to 176 N.m (130 lb ft).
30. Check the gap dimension. Continue tightening until the correct gap dimension is reached. Dimension a = 2.3 mm (0.091 in).
