Cobalt L4-2.2L (2008)
3. Remove the 2 front mounting nuts (2).
4. Remove the 2 rear mounting nuts (3) and the shifter.
Installation Procedure
1. Position the shifter on the studs and install the front 2 nuts (2).
Notice: Refer to Fastener Notice .
2. Install the 2 rear nuts (3).
Tighten the nuts to 25 N.m (18 lb ft).
3. Install the shift cables. Refer to Shift Control Cable Replacement (See: Shift Linkage/Shift Cable/Service and Repair/MU3 - Manual Transaxle) .
4. Install the console. Refer to Front Floor Console Replacement .