Cobalt L4-2.4L (2007)
Trunk / Liftgate Shock / Support: Service and Repair
Rear Compartment Lid Strut Replacement
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the
rod because damage or bending will result.
1. Open and support the rear compartment lid.
2. Using a small flat bladed tool, release the clip retaining the rear compartment lid assist rod to the lower assist rod ball stud.
3. Using a small flat bladed tool, release the clip retaining the rear compartment assist rod to the upper assist rod ball stud.
4. Remove the rear compartment lid assist rod from the vehicle.
Installation Procedure
1. Press the rear compartment lid assist rod onto the upper rear compartment lid assist rod ball stud.
2. Press the rear compartment lid assist rod onto the lower assist rod ball stud.
3. Ensure that both clips are fully seated on the rear compartment assist rod.
4. Close the rear compartment.
