Cobalt L4-2.4L (2007)
3. Hand start all the frame bolts while aligning the frame to the paint marks.
Notice: Refer to Fastener Notice.
4. Tighten the frame bolts.
Tighten the bolts to 100 N.m plus 180 degrees (74 lb ft) plus 180 degrees.
5. Lower and remove the hydraulic table.
6. Connect the lower control arm to the steering knuckle.
Important: The torque sequence must be followed in the order that is listed.
7. Install the ball joint pinch bolt and nut.
1. First Pass: Tighten the nut to 50 N.m (37 lb ft).
2. Reverse the nut 3/4 turn.
3. Second Pass: Tighten the nut to 50 N.m (37 lb ft) plus 30 degrees.
