Cobalt L4-2.4L (2007)
The fourth piece of tape (4) is located at the nine o'clock position.
Repeat Step 11 for the left rear seat back pivot bracket.
Install two pieces of 3M(TM) Squeak Reduction Tape, P/N 06356, or equivalent around the left and right rear seat cushion retainers (1). Refer to Rear
Seat Cushion Replacement in SI.
Install the left and right rear seat back assemblies. Refer to Split Folding Seat Back Replacement in SI.
Install the rear seat cushion back into the vehicle and lock the seat cushion retaining hooks.
Raise the two rear split seats up into position and push back until a click is heard.
Check for proper routing of the rear seat belts. Push and pull forward on the seat backs to verify the seats have locked into place.
Tip
If the seat doesn't lock into place, check the rear seat back striker to the rear seat back latch assembly for proper alignment and adjust.
Verify that the noise has been eliminated.
Parts Information
Warranty Information
