Cobalt L4-2.4L (2007)
6. Align the center floor duct with the HVAC module.
7. Push the center floor duct up while rotating rearward in the vehicle to install on the HVAC module.
8. Push down on the floor duct while rotating the center floor outlet ducts to align the ducts.
9. Slide the center floor outlet duct down into position in the floor ducts.
10. Install the accelerator control pedal.
11. Pull back the carpet and place the left center support bracket into position.
12. Install the left center support bracket nuts.
Tighten the left center support bracket nuts to 10 N.m (89 lb in).
13. Install the left side front floor console extension panel.
14. Install the BCM to the vehicle.
