Cobalt L4-2.4L (2007)
4. Remove the tool (1) from the intake camshaft side of the timing chain assembly.
5. Remove the tool (1) from the exhaust camshaft side of the timing chain assembly.
6. Install a 24 mm wrench onto the hex on the camshaft in order to hold the camshaft.
Notice: Refer to Fastener Notice.
7. Tighten the NEW camshaft actuator bolt.
Tighten the bolt to 85 N.m (63 lb ft), plus an additional 30 degrees using the J 45059.
