Cobalt L4-2.4L (2007)
1. Lubricate the solenoid valve O-ring seals with clean engine oil.
Notice: Refer to Fastener Notice.
2. Install the intake (2) CMP actuator solenoid valve and bolt, as required.
Tighten the bolt to 10 N.m (89 lb in).
3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required.
Tighten the bolt to 10 N.m (89 lb in).
4. Connect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
5. Install the intake manifold cover.
