Cobalt L4-2.4L (2007)
Notice: Refer to Fastener Notice.
3. Carefully push the fuel injectors into the cylinder head ports.
4. Install the fuel rail bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Connect the engine harness electrical connector (1) to the MAP sensor.
6. Connect the engine harness electrical connector (2) to the fuel injector harness.
7. Install the fuel injector harness connector clip to the intake manifold.
8. Remove the caps or plugs from the fuel line and the fuel rail.
9. Connect the fuel feed line quick connect fitting (4) to the fuel rail.
10. Connect the negative battery cable.
11. Inspect for fuel leaks using the following procedure:
