Cobalt L4-2.4L (2007)
Positive: Service and Repair
Battery Positive Cable Replacement (Underhood Junction Block to Starter)
Battery Positive Cable Replacement (Underhood Junction Block to Starter)
Removal Procedure
Important:
*
Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
*
Always route the replacement cable the same way as the original cable.
1. Disconnect the negative battery cable.
2. Remove the junction block cover.
3. Remove the junction block nut (1).
4. Remove the positive battery cable terminal (2) from the junction block stud.
5. Remove the positive battery cable clip (3) from the engine control module (ECM) bracket.
6. Raise and support the vehicle. Refer to Vehicle Lifting.