Cobalt L4-2.4L (2007)
Important: Note the depth and orientation of the old bushing before removal.
12. Using the J 44570, install the J 44570-1 (2) with the lip between the axle sleeve and bushing flange. It may require tapping with a hammer to fully
seat the tool.
13. Insert J 44570-3 (1) through the J 44570-1 (2) and the axle bushing.
14. Install the washer and nut by hand, tightening until the tool is snug.
15. Using a hammer, drive the bushing from the axle sleeve.
16. Disassemble the tool and remove the bushing.
Installation Procedure
Important: The axle bushings must be installed in the correct orientation as shown.
1. Slide the new bushings into the axle sleeve in the same orientation noted during removal. Make sure the rubber end (1) is facing inboard and the
largest void (2) is in line with the wheel hub center (3).
2. Place the J 44570-1 (2) onto the bushing. Make sure the bushing is still oriented correctly.
