Cobalt L4-2.4L (2007)
2. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Notice: Refer to Fastener Notice.
3. Install the clutch cover to flywheel bolts.
Follow the tightening sequence. Tighten the bolts to 24 N.m (18 lb ft).
4. Remove the J 43482.
Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
5. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
6. Install the transmission. Refer to Transmission Replacement for the - M86/M94 Getrag transaxle.
7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding.
8. Connect the negative battery cable.
