Cobalt L4-2.4L (2007)
Important: It may be necessary to remove the chamfer (bevel) from the edge of an 18 mm socket in order to get full engagement on the
thin-headed flywheel bolts.
6. Remove and discard the manual transaxle flywheel bolts, if equipped.
Important: Do not orientate the flywheel to the crankshaft. It is balanced separately from the engine.
7. Remove the manual transaxle flywheel, if equipped.
8. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
Installation Procedure
1. Install the manual transaxle flywheel, if equipped.
Notice: Refer to Fastener Notice.
