Cobalt L4-2.4L (2007)
2. Install the transmission mount to mid-rail bolts.
Tighten the bolts to 27 N.m (20 lb ft).
3. Using a floor jack, raise the transmission until it contacts the transmission mount.
Important: The transmission mount to transmission bolts must be hand started. Do not pry the transmission or mount to align the holes.
4. Hand start the transmission mount to bracket bolts using the following sequence:
1. Rear bolt
2. Middle bolt
3. Front bolt
5. Using the previous sequence, tighten the transmission mount bolts.
Tighten the bolts to 50 N.m (37 lb ft).
6. Install the underhood electrical center bracket to the vehicle and install the electrical center into position on the bracket. Refer to Underhood
Electrical Center or Junction Block Bracket Replacement.
