Cobalt L4-2.4L VIN B (2006)
6. Locate and drill out all the factory welds from the outside surface of the rail.
7. Remove the front bumper impact bar bracket.
Installation Procedure
1. Prepare all mating surfaces as necessary.
2. Apply GM-approved Weld-Thru Coating or equivalent to all mating surfaces. Refer to Anti-Corrosion Treatment and Repair.
IMPORTANT: Verify the location of the front rail using 3-dimensional measuring equipment.
3. Position the impact bar bracket on the rail and clamp in place.
4. Plug weld accordingly.
5. Clean and prepare all of the welded surfaces.
6. Install all of the related panels and components.
7. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
8. Paint the repaired area.
9. Connect the negative battery cable.
10. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
