Cobalt L4-2.4L VIN B (2006)
Note:
Do not use any air powered or electric tools to rotate the threaded shaft of the fixture EN 45680-851/cylinder bore liner installer EN
45680-853 assembly or damage to the cylinder bore liner will occur.
7.
Using a ratchet, rotate the threaded shaft of EN 45680-85 fixture and EN 45680-853 cylinder bore sleeve installer assembly in order to install the
cylinder bore sleeve into the engine block.
8.
Do not completely seat the cylinder bore sleeve in the block. Leave approximately 1/16 inch of the cylinder bore sleeve above the surface of the
cylinder block.
9.
Using a torque wrench, tighten the threaded shaft of the EN 45680-851 fixture and EN 45680-853 cylinder bore sleeve installer assembly to 102
Nm (75 lb-ft) in order to completely seat the cylinder bore sleeve in the cylinder block. With the cylinder bore sleeve properly installed, a minimal
portion of the cylinder bore liner flange will protrude above the block deck surface.
