Cobalt L4-2.4L VIN B (2006)
1. Install the mode actuator assembly.
IMPORTANT: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
2. Install the mode actuator assembly screws.
Tighten the screws to 2.2 N.m (19 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the mode actuator electrical connector.
4. Install the air temperature actuator.
5. Start the engine and let run for one minute.
IMPORTANT: Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If
interrupted improper HVAC performance will result.
