Cobalt L4-2.4L VIN B (2006)
IMPORTANT: This inflatable restraint sensing and diagnostic module (SDM) has 2 fused power inputs. To ensure there is no unwanted SIR
deployment, personal injury, or unnecessary SIR system repairs, remove both AIR BAG and SDM fuses from the BCM fuse center. With the AIR
BAG fuses removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not
indicate an SIR system malfunction.
6. Remove the right/passenger outer trim cover from the instrument panel (I/P) (3).
7. Remove the connector position assurance (CPA) from the I/P module connector (1).
8. Disconnect the I/P module connector (1) from the vehicle harness connector (2).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the I/P module connector (1) to the vehicle harness connector (2).
3. Install the CPA to the I/P module connector (1).
4. Install the right outer trim cover to the I/P (3).
5. Install the AIR BAG (1) and SDM (2) fuses into the BCM fuse center.
6. Install the BCM fuse center cover.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle.
