Cobalt L4-2.4L VIN B (2006)
11. Install the CPA to the seat belt retractor pretensioner - RF connector.
12. Install the lower center pillar.
13. Install the AIR BAG (1) and SDM (2) fuses into the BCM fuse center.
14. Install the BCM fuse center cover.
15. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash, then turn OFF.
16. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle.
SIR Disabling and Enabling Zone 8
SIR DISABLING AND ENABLING ZONE 8
DISABLING PROCEDURE
1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module (BCM) fuse center then remove fuse center cover.
